Quik Lok MST-001

MST/001 is the multifunction table stand developed by Quik Lok to allow maximum adjustment versatility in the smallest possible size.

Thanks to the large top plate 25 cm wide and 29 cm deep you can use this support to place your nearfield monitors on the worktop at the height and angle that best suits your needs; the front part of the shelf is bent with a flange of 1 cm which, in case of angle of the top, it does not allow the equipment to slip thanks to the 23 cm x 6 cm rubber adhesive strips included.

At the same time, the MST 001 is also useful to place devices such as mixers, tablets or small midi controllers.

The base 25 cm wide and 30 cm deep is equipped with four feet in the corners that are adjustable in height thanks to a screw system that allows a rise from the tabletop from a minimum of 1 cm to a maximum of 2 cm in order to compensate any differences in height.

The upper plate is equipped at the base with a joint capable of allowing angles from 0° to 90° in order to obtain the right directionality of the monitors when raised, or the correct angle of mixer or MIDI controller for easy use.

MST001 is adjustable in height by loosening the screw with the characteristic "Q" of Quik Lok, placing the locking pin in one of the five holes on the tubular that is linked on the base and finally tightening the knob. Through this procedure different heights can be obtained: from a minimum of 29 cm from the top up to a maximum of 37 cm, with increments of 2 cm for the intermediate positions (29, 31, 33, 35 cm).

SPECIFICATIONS OF THE MULTIFUNCTION STAND MST/001 BY QUIK LOK

Material: Steel

Finish: Satin black

Base size: 25 cm x 30 cm

Top shelf size: 25 cm x 29 cm

Adjustable feet height excursion: min 1 cm, max 2 cm

Height: 29, 31, 33, 35, 37 cm

Angle: 0°/90°