Omnitronic XPA-1800 Amplifier

PA amplifier with limiter, 2 x 900 W / 4 ohms, 2 x 650 W / 8 ohms

3 operating modes can be selected (stereo, parallel or bridged)
Input sensitivity adjustable
Speaker switch-on delay
2 level controls
Each channel with LED for activated protective circuit (protect) and output meter with clip LED
Complete protection set
Signal inputs via XLR or RCA connectors
Speaker outputs via lockable speaker jacks and pairs of screw terminals
Class H circuitry
Air flow from front to rear
The device is cooled by temperature-controlled fan
(19") 48.3 cm rack installation 2 U

Power supply: 230 V AC, 50 Hz
Power consumption: 765 W 1/8 power
Output power: 2 x 900 W RMS (4 ohms)
2 x 650 W RMS (8 ohms)
1800 W RMS bridged (8 ohms)
Power connection: Mains input via P-Con (blue), mounting version power supply cord with safety plug (provided)
Frequency range: 20 - 20000 Hz
S/N ratio: >100 dB
THD: <0,5 % at 1 kHz
Cooling: 2 x temperature-controlled fan , Air flow from front to rear
Impedance: Input: 20 kOhm , bal.
Input: 10 kOhm , unbal.
Circuitry: Class H
Slew rate: >10 V/µs
Damping factor: >200
Control elements: Power switch, level control per channel, mode switch (stereo/parallel/bridged), Input sensitivity switch
Controls: Short-circuit; overheat; DC voltage; power on/off transients; softstart; power on/off transient
Status LED: Power, level meter, clip, bridged, protect
Connections: Input: line via 2 x 3-pin XLR
Input: line via 1 x stereo RCA
Output: speaker via 2 x speaker built-in socket (F)
Output: speaker via screw terminal
Input sensitivity: 0,775 V; 1,4 V , switchable
Housing design: (19") 48.3 cm rack installation 2 U
Dimensions: Width: 48,3 cm
Depth: 35,4 cm
Height: 8,9 cm
Weight: 14,65 kg