dj service
shopping_cart
djservice.ee »  Stuudio » Mikrofonid » sE7
sE Electronics sE7

sE Electronics - sE7

Artnr: IDS0074619
Tarneaeg: 2-10 tööpäeva.

SE Electronics
99.00 EUR/tk

Igakuine kuumakse alates 6.25 euro

Teave:

The sE7 is a high-quality back-electret small diaphragm condenser microphone intended for a wide range of studio and live sound applications, from acoustic guitars to pianos to drums and beyond.

With an optimized acoustic design, discrete class-A circuitry and a transformerless output, it delivers clear, natural sound quality at all frequencies, without suffering from fizzy highs or a lack of low-frequency punch.
The discrete electronics and the switchable attenuation pad ensure a high dynamic range, with high sound pressure level (SPL) handling capability and extremely low-noise components. The switchable low-cut filter helps eliminate rumble or footfall noise, and can also compensate for an excess of bass frequencies caused by the proximity effect. This enables the sE7 to close-mic many instruments including electric guitar speaker cabinets, brass instruments and drums.

 

Capsule Type: 1/2“ back-electret condenser capsule

Polar Pattern: Cardioid

Frequency range: 20 Hz - 20 kHz

Sensitivity: 19 mV/Pa (-34.5 dBV)

Max SPL: 136 / 156 dBSPL (0/20 dB Attenuation pad)

Equivalent noise level: 16 dB(A)

Dynamic range: 120 / 140 dB (0/20 dB Attenuation pad)

Signal to Noise Ratio: 78 dB

Low-cut filter: 80 Hz, 6 dB/Oct, switchable

Attenuation Pad: 20 dB, switchable

Powering: 48 Volts according to IEC 61938

Electrical Impedance:

Recommended load impedance: >1k Ohms

Current consumption: 3.0 mA

Connectivity: 3-pin male XLR connector

Dimensions: Diameter: 23mm (0.91 in), Length 120mm (4.72 in)

Weight: 128 g (4.52 oz.)